IOM J500.32
Jerguson
®
LumaStar
™
2021.05
5
16633 Fol
tz Parkway ● Strongsville, OH 44149 USA ● Telephone: +1 (440) 572-1500 ● Fax: +1 (440) 238-8828
www.clark-
reliance.com ● [email protected]
6.2 Components
There are three main components that make up the LED illuminator: the light strip, the power supply, and the cord
connecting these two main pieces. The cord may have more than one piece depending on the required distance
between the illuminator and the power supply. The power supply is constructed of aluminum or stainless steel, a
conduit sealing device and a stainless steel I.S. connector. The light bar is constructed of aluminum or stainless
steel, glass and silicone. Questions regarding acceptable applications should be directed to The Clark-Reliance
®
Corporation.
6.3 Installation Wiring
CAUTION:
All lights are tagged with the service conditions for that particular unit. These specifications
are located on the Jerguson tag on the power supply housing and
are contained in the “Specifications”
section of this manual. Do not use or refer to specifications listed on red label on the power supply
housing. They are specifications for generic use. Review the ratings prior to installation and again prior
to start-up, to ensure proper operation in the installed environment. Should there be any doubt as to the
applicability of a unit for the installed environment, consult the factory before placing the unit into
service.
All installation steps should be performed by a qualified technician and should be executed in accordance with all
applicable national and local codes.
The light and power supply should be checked to ensure that they contain no foreign matter, and that the end
connections are clean, undamaged, and in line with existing conduit.
