INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
SUBJECT TO TECHNICAL CHANGES.
13
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
3.
Installation
3.1
General
Safety is only guaranteed if the Zero Point System (ZPS) is properly
connected according to applicable safety regulations.
CAUTION:
Only qualified personnel may connect the ZPS to the pressure supply.
If several ZPS are installed side by side, care must be taken that the
height variation of the contact surfaces remains within 0.02 mm.
The spacing tolerances between the ZPS should not /- 0.01
mm.
If the tolerances are exceeded, please consult with Jergens.
The change pallet to be clamped with the integrated pull studs must
always rest against the contact surface of the Zero Point Systems in
the clamped state (a slanted position of the change plate must be
prevented).
K5.3,
K10.3:
The integrated sensors display the status of the ZPS (opened, clamped)
in the mounting flange. To check that the change pallet is in process-
secure contact, it must be separately detached.
The presence of the
clamping nipple is not sensed.
K20.3:
The integrated sensors display the status of the ZPS (opened, clamped)
in the mounting flange. To check that the change pallet is in process-
secure contact, it must be separately detached.
The presence of the
pull stud is not queried, that is, the sensor (clamped) gives a signal
only when the
pull stud
is present.
Attention when using in the welding area: Excessively high welding
currents can lead to malfunctions of the inductive sensors. In this case, a
suitable bypass for the currents must be arranged.
