SUBJECT TO TECHNICAL CHANGES.
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
7
INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
0.6
Restrictions on use
The Zero Point system (ZPS) may be used solely for the uses
specified in the installation manual, and only in combination with
the components recommended and approved by JERGENS INC.
Permitted use of the Zero Point System (ZPS)
: The ZPS is a spring-
actuated single-acting clamping element that clamps a clamping plate or a
workpiece pressure-free and self-locked with the Jergens Pull Stud. It is
intended for installation on or in machines or systems, and may be used
only within the scope of its technical data. The maximum loads and
operating pressures specified by the manufacturer must not be exceeded.
All other types of use must be agreed with the manufacturer.
The ZPS is suitable only to a limited extent in certain explosive
environments. Further information regarding this application is contained
in separate installation instructions.
0.7
Type plates
A label or the type plate of the manufacturer is affixed to the Zero Point
System.
CAUTION:
Labels must not be removed under any circumstances, even if the
equipment is to be resold.
Should any label be damaged or become detached, please
contact JERGENS INC. to obtain a copy.
In
all
communications with JERGENS INC.
,
pl
e
ase always
mention the model stamped
on the label. Disregarding these
provisions releases JERGENS INC. from any
liability for
damage or accidents caused thereby. In this case, the
operating company is solely liable to the authorities.
