SUBJECT TO TECHNICAL CHANGES.
JERGENS INC. · PHONE: 216.486.5540 · FAX: 216.481.6193 /553720 / 553721/
4
INSTALLATION MANUAL
ZPS-
K5.3,
K10.3, K20.3 CLAMPING
MODULE WITH SENSOR
MONITORING, MOUNTING FLANGE
877.426.2504
0.
Introduction
CAUTION:
The original configuration of this system must not be altered
under any circumstances.
Using this system for purposes other than those which the manufacturer
intended can damage the system or harm the operator. The
manufacturer's consent must be obtained before working on materials
other than those described in these instructions.
Symbols used
Machining processes, which represent a risk and which can cause injuries
or harm to health, if they are not properly performed.
Machining processes that may be performed only by qualified specialist
personnel. The possibility of residual risks cannot be ruled out.
0.1
Operating personnel
As mentioned above, certain operations must be performed
exclusively by qualified or trained personnel. The following standard
features are used to describe the qualification level:
Qualified personnel have sufficient technical knowledge or work
experience to be able to recognize and prevent possible dangers
(engineers and technicians).
Trained personnel are appropriately instructed and/or monitored by
qualified persons to be able to recognize the dangers and prevent them
(personnel assigned to operation or maintenance). They must have the
following qualifications:
