Jensen A540 Di D-1703 EDR 80km/h, Operating Instructions Manual

Page: 60 / 98

Operating instructions HMCflex
15/23 © ehb errors and omissions excepted
4 Explanations of the adjustable parameters
[1] Settings
Parameters Explanations
[1] language
language You can choose between German, English, French and Spanish
[2] sensors
temperature The HMCflex can be factory set for the usual types of temperature sensor. The
type of temperature monitoring is programmed under [10] Inputs/Outputs.
oil pressure The HMCflex can be factory set for the usual types of oil pressure sensor. The
type of oil pressure monitoring is programmed under [10] Inputs/Outputs.
pulse/revolution The number of pulses from the pulse generator or the number of pole pairs on
the alternator must be stored here. With regard to this, see point 4 further set-
tings and explanations.
[3]
output
ETR-PullCoil Type of operating magnet, setting for pull coil:
Operating magnet ETR: An operating magnet (ETR - energise to run) means
a lifting magnet, which enables the flow of fuel when voltage is applied and
which must remain energised during operation of the engine.
Switch-off magnet ETS: A switch-off magnet (ETS - energise to stop) means
a lifting magnet, which requires voltage to stop the engine.
None: Magnet without pull coil
ETR-HoldCoil Type of operating magnet, setting for hold coil:
Operating magnet ETR: An operating magnet (ETR - energise to run) means
a lifting magnet, which enables the flow of fuel when voltage is applied and
which must remain energised during operation of the engine.
Switch-off magnet ETS: A switch-off magnet (ETS - energise to stop) means
a lifting magnet, which requires voltage to stop the engine.
None: The operating magnet is switched via the HMCflex
PIN 11 Alarm output or speed regulation magnet with Options options: setting for the
pull coil. You can choose between ETR (energised to run), ETS (energised to
stop), None
speed-holdCoil Type of speed adjustment magnet, setting for the hold coil: you can choose
between ETR (energised to run), ETS (energised to stop), None
Speed time 1 Time period after start-up, after the speed adjustment magnet becomes active.
Settings between 1 and 99 seconds can be programmed.
CDowntime Setting for the engine's cool down time. Settings between 0 and 15 minutes are
possible.