Jensen A540 Di D-1703 EDR 80km/h, Operating Instructions Manual

Page: 40 / 98

KTR Kupplungstechnik
GmbH
D-48407 Rheine
C L A M P E X
®
K T R 4 0 0
m o u n t i n g i n s t r u c t i o n s
KTR-N
sheet:
edition: 40818 E
3
2
Gezeichnet: 06.09.01 Sha/Hg Ersatz für: KTR-N 40840 Verteiler
Urheberschutz
gemäß DIN 34
Geprüft: 06.09.01 Sha Ersetzt durch: W K V VA M KC
Assembly
•
Check the position of shaft and hub regarding the stipulated tolerance (h8/H8).
•
Clean the hub bore and the shaft and afterwards oil them with thin-bodied oil (e. g. Castrol 4 in 1 or
Klüber Quitsch Ex).
!
C A U T I O N !
Do not use oils and greases with molybdenum disulphide or high pressure
additions as well as slide grease pastes.
•
Detach the screws slightly. To make the assembly easier, fix the pressure rings in the front and in
the back via the respective forcing thread by 2 clamping screws (see picture 3 and 4). Insert
clamping set KTR 400 between shaft and hub.
picture 3: fixing of the front pressure ring picture 4: fixing of the back pressure ring
•
Remove the clamping screws used for the fixing and screw them into the threads of the back
pressure ring.
•
Slightly tighten the clamping screws manually and align the clamping set with hub part.
•
At KTR 400 please make sure that the pressure rings are parallel to each other and in an angle of
90° to the shaft/hub.
•
Tighten the clamping screws evenly and crosswise. Increase the tightening torque step by step.
This procedure must be repeated until the tightening torque indicated in table 1 is reached with all
clamping screws.
Table 1:
type of clamping set 400
screw size M M6 M8 M10 M12 M14 M16 M20 M22
tightening torque T
A
[Nm] 17 41 83 145 230 355 690 930
!
A T T E N T I O N !
During the assembly there can be a slight axial displacement of the hub opposite to
the shaft.