Jensen A540 Di D-1703 EDR 80km/h, Operating Instructions Manual

Page: 24 / 98

8. In the event of the cap of the knife falling off, the chimney on that side will
shake and stop!
9. Only attempt the laying and removal of the V-belt when there is no movement!
10. Safety features must be fitted according to the regulations!
11. Safety preparations such as welding, sharpening, drilling etc. are permitted to
be carried out only by specialists when working on the frame, axle, pulley
mechanisms and safety devises. This work may only be carried out in an
autherised garage!
Maintenance for the motor.
1. No one must wait in front of the running motor!
2. When working with a primarily battery powered motor (negative pole) squeeze
and then pull back the sparkplug!
3. Under high pressure, high pressure fluids will appear (e.g. from the fuel
injection nozzle.) This liquid can cause significant damage to the skin. Seek
medical advise immediately if contact with the skin is made as there is a
danger of infection!
4. Take care with the quality of oil and power and ensure that they are kept only
in approved containers!
5. Take care when pouring hot oil as there is a danger of being burnt!
6. Take care when removing the cool-lid. The cooling fluid is kept under
pressure so there is a danger of being burned!
7. The oil, power, cooling fluid, batteries and filters should be stored separately!
Electrical construction.
1. When working on the electrical construction disconnect the minus pole of the
battery!
2. When disconnecting the battery make certain that the minus terminal is
disconnected first and then the plus terminal! When reconnecting reverse the
sequence!
3. Take care with the gas from the batteries as it is explosive!
4. Never take open flames or sparks near the batteries!
5. When recharging the batteries remove all plastic coverings so that the
accumulation of explosive gases is avoided!
6. Take care when moving with battery fluids as they are corrosive!
7. Use only the prescribed fuses. If any stronger than these are used then the
electrical structure will be destroyed resulting in the risk of fire!
8. Always administer the plus terminal with a covering. If all are turned off at once
there is a risk of explosion!