7.
Pay attention to the sliding clutch in the Cardan shaft and ensure that it is fully
covered by the safety feature (machine and tractor) The covering of the safety
features must be at least 50mm in total!
8.
Before turning on the PTO make sure that its high rotation speed power of the
propulsion machine is equal to the permissible rotation speed of the Wood
chipper!
9.
Before turning on the PTO take care that no one is in close enough proximity
of the machine to get hurt!
10.
When working with the PTO allow no one to stay in the turning area of the
PTO shaft or the Cardan shaft!
11.
After switching off the PTO it can continue to rotate. During this time do not
step too close to the machine. Only resume work when it is totally still!
12.
When turning the machine, ensure that the cardan shaft is suspended in the
preparatory position!
13.
If there are any blockages in the Cardan Shaft remove them immediately
before you recommence work!
Working with the Wood Chipper
1.
Study the safety measures for the smooth operation of all the functions!
2.
When in use, the Wood chipper must be on a flat and firm area!
3.
Materials in the entrance, the cords and rollers for example, cannot be made
to be fully safe because of their functions; therefore, during the running of
these moving parts it is necessary to have enough safety precautions!
Respect the other parts as well as they may also be not completely safe!
4.
Never leave the Wood chipper unattended when in use!
5.
Only operate the machine in good light and good visibility!
6.
Do not place hands in the funnel – rotating pieces!
7.
If someone climbs too far into the machine, the control bar should be pulled to
stop the machine immediately
.
8.
The machine must only be operated when the chimney is fixed!
9.
Put in the waste reeds and litter so that it is not facing anyone and no one is in
danger of being hurt by flying chopped-up pieces of wood!
10.
Only deposit the wood into safe places!
11.
Do not exceed the allowed wood thickness!
12.
Only remove the surplus pieces etc.. with help and when the machine is
switched off (wood pieces and similar)!
Conditioning, attendance and repairs
1.
When carrying out repairs the machine must not be in motion. Check the
brakes and the under wedge and remove the keys to the machine!
2.
After turning off the power, the flywheel can continue to rotate. During this
time do not go too near to the machine. Only when it is totally still can work on
it begin!
3.
Replacement parts must at least be equivalent to the manufacturers’!
4.
When working under the raised cover of the machine, take care that there is
enough support for the cover!
5.
When handling sharp objects e.g. chopping knives ensure that the correct
protective clothing is worn (gloves, shoes etc.)!
6.
When sharpening knives protective glasses must be worn!
7.
Only remove the cap of the knife when the sharpener is not moving!
Summary of Contents for A540 Di D-1703 EDR 80km/h
