Jensen A540 Di D-1703 EDR 80km/h, Operating Instructions Manual

Page: 30 / 98

4
Operating instructions
Disengage feeding:
Push the green button
Engage feeding:
Push the green button a second time
Stop
Push the red button
Recommended instructions during operation
Branch wood to be fed always with heavier end towards retraction rollers.
Should rotation of knives - disc drop during operation, push the disengaging lever,
wait until disc reaches full operating rotation again, then activate feeding again.
Check all screws and nuts for tightening.
V- belts
Check suspense regularly and re-tighten, if necessary.
Knives and counter – knife
In order to achieve an easy cut, always keep a sharp edge. The blades edges should
always have an inner distance of 0,5mm towards the edge of the anvil. The outer
distance between blades and anvil is a little bit wider.
Check knives regularly.
Knives, which due to resharpening get too narrow apart from the anvil have to be
compensated by shims.
Caution:
Even flywheels moved by hand, when replacing knives f.i., have enough
force, due to their weight, to cause squeeze injuries.
Please take care of the following information to sharpen the blades.