42
Learning to Use the Lean Clean 360 Cleaning System
Modifying a Program
Process Variables that You Can Modify
You can set the following program parameters and then save the changes as a
new program for future use:
Wash cycle time
Rinse cycle time
Fresh water rinse cycle time (if equipped)
Fresh water rinse on or off (if equipped)
Dryer cycle time
Dryer temperature set point
Wash tank water temperature
Rinse tank water temperature
Ultrasonics on or off in wash (if equipped)
Ultrasonics on or off in rinse (if equipped)
Sonication time in wash and rinse cycles (if equipped)
Rotation on and off in wash and rinse
Tilt on or off (if equipped)
Tilt cycle time (if equipped)
Tilt angle (if equipped)
Cool down cycle time
Steps to Modify a Program
These are the steps you follow to modify a cleaning program:
1.
Ensure the Lean Clean is in idle mode and the washing chamber door
is open.
2.
Using the touch screen monitor, press the
Selects Manual Mode Control
button. Then press the
Motors/Pumps/Drains
button and enter your
password into the
Options
screen.
3.
Press the
Heat/Sonics/Rotator Set-up
button and enter your password.
4.
Press the
Program Cycle Data Entry
button and enter your password.
