Javad JNSGyro-4T, Operator'S Manual

Page: 45 / 116

www.javad.com JNSGyro-4T Operator’s Manual 2-15
C O N F I G U R A T I O N
MinPad Configuration
Note that a log file opens immediately after turning AFRM on. This startup
file is not considered a file rotation event; the AFRM counter will not
decrement.
Values are 0 to [231-1]. The default value is 0 (zero). Zero means that an
unlimited number of log files will be created.
Notice: The board's memory holds up to 512 files.
• Files (remain) - specifies the number of files left for the board to create in
AFRM.
• Values are 0 to [231-1]. The default value is zero.
• Automatically remove old files - when no free memory is available to log
data, automatically removes the earliest log file. If this parameter is
enabled, your board will erase the file with the earliest file creation time/
date. AFRM must be enabled to use this FIFO (First-In, First-Out) feature.
The default value is off (disabled).
FN Key Mode parameter
You use these two radio buttons to program how the JNSGyro-2(T) will react
when pressing the FN key.
• LED blink mode switch - pressing FN will toggle between the MinPad's
normal/extended information modes and start/stop data recording of Static
measuring.
–FN pressed less than 1 second: changes the information mode (Normal or
Extended Information (EI) Modes).
–FN pressed from 1 to 5 seconds: starts or stops recording (Static post-
processing mode).
• Occupation mode switch - pressing FN (less than one second) will insert
into the corresponding log file a message indicating that the measuring type
has been changed from static to kinematic, or vice versa. If the REC LED
blinks green, the current mode is dynamic, if it blinks orange, the current
mode is static. For more details, refer to the
MinPad User's Manual and
PCView Software Manual .
Data Recording Auto-start parameter
These radio buttons allow you to program your board's behavior in the event
of a power failure.