Japan Radio Co. JLR-7600, Instruction Manual

Page: 119 / 184

4-77
4.15.17 Inputtig/Outputting Waypoint, Route and Track
4.15.17.1 Outputting Waypoint, Route and Track
A waypoint list and the destination of a route list, a route, and a trip can be outputted to external PC.
The ports used with an output are DATA IN/OUT2 and 3.
By outputting in an exclusive format, it can save by a CSV file. In order to use an exclusive format, PC
tool for exclusive use is needed.
When you use PC tool for exclusive use, be sure to make the bit rate of DATA IN/OUT2 and 3 the same.
When outputting by NMEA, general-purpose tools, such as a hyper-terminal, can be used. In this case,
the output of a track cannot be performed. The sentences to be used are WPL and RTE.
The outline of the data which can be outputted is as follows.
ALL WAYPOINT:
Output all the waypoint.
ALL ROUTE: Output all the route.
ALL WROUTE: Output all the waypoint and route.
ALL TRACK: Output all the trip.
When you output and input, connect with PC as follows. When connected with other equipment,
change connection into PC temporarily.
NWZ-4610
display Personal computer
14 pins COM port
Color Pin
Purple (7) Pin Operation
Pink (10) (2) RX
Bright green (12) (3) TX
Brown (13) (5) GNG
1) When outputting in a NMEA format
1. Refer to "4.15.1 Change to a maintenance mode" and display the maintenance menu.
2. Press the key to select "INTERFACE" "DATA I/O" and press the key.
3. Select "ROUT WPT" from DATA IN/OUT2, and press the key.
4. Select NMEA vertion from "VERSION", and press the key.
5. Select the bit rate linked with PC from "BIT RATE", and press the key.
6. Select the data outputted from "OUTPUT DATA", and press the key.
In the case of NMEA data output, the output of "ALL TRACK" cannot be performed.
7. Press the key to select "SEND", and press the key.
8. Since the following is displayed, select "YES".
It is displayed as "SENDING" and data transmission is carried out.
YES
ARE YOU SURE
？
YES NO
SENDING
Short in (7) and (13)
Procedure