Janson Controls FC100 Series, Manual, Page: 71 / 108

71
Group P4 : Secondary Application Group
Default value 5 . 0
Jog frequency setting
P400
Setting Range : 0 ~ Max Frequency Unit : 0 . 1
Jog frequency setting is usually applied to trial run . This function can only
be through external terminal .
When JOG function is achieved , other instruction is invalid . When JOG
signal is open , inverter decelerate to stop , JOG acceleration / deceleration
time is set in the 4th acceleration / deceleration parameter .
Control priority level :
Jog - External Multi Speed - PLC Operation Means - PID Means - Raingle
Wave ( traverse function ) - Winding - Frequency Conversion Setting Means
Default value10 Acceleration Time 2
P401
Default value10 Acceleration Time 2
P402
Default value20 Acceleration Time 3
P403
Default value20 Acceleration Time 3
P404
Default value2 . 0 Acceleration Time 4
P405
Default value2 . 0
Acceleration Time 4 P406
Setting Range : 0 ~ 999 . 9S Unit : 0 . 1
FC100 series inverters can set 4 acceleration / deceleration time . For normal
operation , the default selection is the acceleration / deceleration time 1 . For
JOG operation , the default selection is acceleration / deceleration time 4 .
Default value100
Setting value of counter
P407
Default value 50 Middle value of counter
P408
Setting Range : 0 ~ 999 . 9S Unit . 1
Fc100 Series inverter design 2 group of counters , pulase signal less than 250Hz
can be accepted through multi - function terminal , when exeunt value reaches
setting value , corresponding multifunction output terminal is ON , input terminal
of counter resets signal through counter , counter resets and begins counting
again .
Default value 150 Acceleration torque limiting level
P409
Setting Range : 0 ~ 200 Unit . 1
Chapter 6 Description of parameter setting
FC100 Series User Manaul