Janson Controls FC100 Series, Manual

Page: 66 / 108

66
17 : Coasting stop
When this terminal is valid , inverter coasting to stop .
18 . Fault reset
Reset the inverter when alarm occurs , this terminal function is sameto that of
the RESET key on the Keypad .
19 . PID function enable
When this contact closes , PID function is enabled . When P601 is set as 2 , PID is
invalid when this contact is disconnected .
20 . PLC function enable
When this contact closes , PLC function starts up , and corresponding PLC
function opens .
21 . Timer 1 starts up
22 . Timer 2 starts up
When this contact closes , timer starts up and begins timing , when the timer
reaches set value , corresponding multifunction output contacting action .
23 . Counter pulse input
This terminal may accept pulse signals of no more than 250 Hz .
24 . Counter resetting
The counted values may be reset and cleared through this terminal .
19 . PLC memory removal
In the running process of PLC program , owing to fault or stopping , inverter will
record status of the program automatically , after the fault is cured and the
inverter is switched on again , the inverter will continue running according to the
program ， when memory removal is valid , program may be reset , and inverter
operates from the beginning .
6
Chapter 6 Description of parameter setting
FC100 Series User Manaul