janitza 14.02.001, User Manual And Technical Data

Page: 23 / 86

www.janitza.com UMG 804
23
8. DIN Rail CT Interface Floating
Board (CTS24FBV)
8.1 Overview
·The DIN Rail CT Interface Floating Boards are
provided with DIN clips for mounting on a stan-
dard 35mm DIN rail. The suggested rail length is
10” (254 mm) or longer.
·DIN rails may be affixed mechanically with fas-
teners or using VHB tape; a permanent adhesive
depending on regional codes.
·Floating Boards also have slots that allow them to
be zip tied in place instead of using DIN rail.
slot for ties
V
8.2 Installation
·DIN Rail CT Interface Floating Boards are orien-
ted according to the panelboard type and num-
bering scheme in one of the four configurations
shown.
·In Top Feed and Bottom Feed orientations the
panelboard type and numbering is identical ho-
wever the user can select to install the Interface
Board with the Smart Port (RJ45 connector) top
facing (Top Feed) or bottom facing (Bottom Feed).
·Ensure that the connections to the UMG 804
Smart Ports match those shown on the orienta-
tion diagrams.
·Smart Ports hosting the Interface Card must be
correctly set in the HTML console under Configu-
ration > General Settings (refer to chapter „14.4.1
General Settings“ on page 65).