janitza 14.02.001, User Manual And Technical Data

Page: 47 / 86

www.janitza.com UMG 804
47
13. Confi guration
The UMG 804 can be confi gured in three different
ways:
1. Via the USB Interface using a USB Flash Drive
with the Confi guration File / spreadsheet. This
is the recommended and most fl exible method.
2. Using the homepage of the device by direct-
ly accessing the UMG 804 over an Ethernet
connection. This can be done by entering the
device‘s IP address into any standard HTML
browser (Ethernet connection to the device
required).
3. Writing to Modbus registers using a Modbus
utility.
13.1 Via USB Interface
The “confi g.csv” fi le can be opened with any text
editor or spreadsheet application. The initial text in
all capitals refers to the fi eld followed by a comma
and the confi guration value. These values may be
changed manually and the fi le saved. It can then
be loaded into the UMG 804 by power cycling the
device with the USB drive installed. Note that the
fi le must be saved as “confi g.csv”.
1. Prepare a USB stick
· The USB fl ash drive needs to be formatted
FAT32
· 32 GB or less in size
· Recommended USB 3.x for reading/write
speed
13.2 Via Device Homepage
See chapter „14.4.9 System“ on page 76.
13.3 Via Modbus Utility
Any user desired Modbus tool can be used to
change the confi guration of the UMG 804 directly
via the corresponding Modbus addresses/regis-
ters. The required Modbus address list is available
on
www.janitza.com.
2. Prepare the confi guration fi le.
If required, rename the confi guration fi le to
“
confi g.csv ”
3. Copy the “ confi g.csv” fi le to the USB stick
4. Turn off the UMG 804
5. Plugin the USB stick to the USB port of the
UMG 804
6. Turn on the device
7. Wait 20 seconds
8. Update is done
9. Remove the USB stick