Jamar Black Cat II Plus, User Manual

Page: 41 / 44

5-3
To charge the battery, first remove it from the Black Cat II Plus Radar
Recorder. Plug the NOCO Genius G1100 Battery Charger (shown
below) into an outlet, then connect it to the terminals of the battery.
******CAUTION******
Never plug a charger into a battery unless you are absolutely sure
of the voltage output and polarity.
The charger has four (4) Charge LEDs - 25%, 50%, 75% and 100%.
These Charge LEDs indicate the connected battery's state-of-charge as
shown in the chart below.
After a battery has been charged, allow it to sit for several hours then
check the voltage to determine if the battery kept its charge. Some reduc-
tion in voltage is acceptable. However, if the battery falls below 13.0
Chapter 5 — Battery Care
Note that the NOCO Genius charger
can charge several types of bat-
teries, including both 6V and 12V
batteries. If the charger is set to
6V, press and hold the Mode button
until the battery lights are flashing.
Then press the Mode button until
12V Lithium is selected.