![background image](http://html1.mh-extra.com/html/jai/rmc-675/rmc-675_user-manual_3220520045.webp)
Appendix 45
RMC-675/RMC-673
8
Appendix
8.1
Front End Detail
Figure 38.
Front End Assembly
8.2
Camera Command Overview
The RMC-675 and RMC-673 cameras can be controlled via RS-232 communications. Commands are sent to the
camera as a string of ASCII characters. Each command begins with a start character of “:” and ends with the end
character CR (Decimal 10, hex D) which is indicated as <cr> in the table below. The camera will acknowledge
successful receipt and processing of the command with the response specified in the table below. If, for any
reason, the camera cannot recognize or process a command, it will respond with the Nack response “:e”<cr>.
The camera will generate output only in response to an input command. Commands are not buffered. A new
command should not be sent until the camera has responded to the previous command. Any input to the camera
will be ignored until processing of the current command has completed and the camera response has been
output. Similarly, all characters received after the end character <cr>, but before the receipt of the start character
“:” will be ignored.
NOTE: The List of Camera Commands is fully comprehensive which includes commands for not only the RMC-
675/RMC-673 series cameras, but also the TM-70X series, the TM-77X series, and the AG-7000 cameras.
Thus, not all the commands listed are valid for RMC-675/RMC-673 series cameras.
Summary of Contents for RMC-675
Page 2: ......
Page 13: ...Hardware Introduction 13 RMC 675 RMC 673 Figure 1 RMC 675 RMC 673 System Configuration ...
Page 81: ......