CV-L108CL
25
8. Functions listed alphabetically by command acronyms
8.1
Command AHRS – Request status after One-Push AWB
This command returns the status of the One-Push AWB function, with the following
parameters:
0=AWB not completed yet
1=Succeeded
2=Error1: Green image too bright
3=Error2: Green image too dark
4=Error3: Timeout occurred
8.2
Command AL – Automatic Line Rate Reference Level
Settings:
0 to 1023
Applicable modes:
No-Shutter with Internal line rate generator
Associated functions:
Command AR
8.3
Command AR – Automatic Line Rate setting
This function will calculate and set the line rate of the camera based on the Automatic
Line Rate Reference Level (as set in command AL) and the scene illumination. Please note
that the aspect ratio of the scanned object will change as the line rate is changed.
Settings:
0 (activate automatic process)
Applicable modes:
No-Shutter with internal line rate generator
Associated functions:
Command AL
Important note
The data can be stored in the camera memory for next start up.
8.4 Command ARST – Auto Reset Mode
This function enables/disables the Auto Reset mode, which prevents offset rising in special
case where line triggers are not received for long period of time.
Settings 0 (off) and 1 (on). Factory default is 0(off).
8.5 Command AW – Activate One-push Auto White Balance (AWB) - Gain
By sending this command via the serial communication, the
gain based
One-Push AWB
function is activated. This function can also be initiated by pressing the rear panel button.
The white balance function takes approximately 3 seconds to complete. During this time
the rear panel LED will show orange.
This function operates in two steps. First the Red-to-Green channel difference and the
Blue-to-Green channel difference is calculated separately. Then the gain of the Blue and
Red channel is automatically adjusted, to obtain the same output level on all three
channels.
Settings:
0 = activate automatic process
Applicable modes:
All
Associated functions:
Command WB
Rear panel One-push WB button.
