CV-L108CL
26
Important Note:
When color temperature of used illumination exceeds the range of adjustment, proper
white balance may not be obtained.
The data can be stored in camera memory for use at next start up.
This function can work on external trigger mode.
Please refer Chapter 7.5 operation mode for the details.
The S/N ratio of the output will change as a result of this function.
8.6
Command AH - Activate One-push Auto White Balance (AWB) - Shutter
By sending this command via the serial communication, the
shutter based
One-Push AWB
function is activated. The white balance function takes approximately 3 seconds to
complete. During this time the rear panel LED will show orange.
This function operates in two steps. First the Red-to-Green channel difference and the
Blue-to-Green channel difference is calculated separately. Then the exposure time of the
Blue and Red Channel is automatically adjusted, to obtain the same output level on all
three channels.
Settings:
0 = activate automatic process
Applicable modes:
Shutter-Select mode only
Associated functions:
Command WB
Important Note:
When color temperature of used illumination exceeds the range of adjustment, proper
white balance may not be obtained.
The data can be stored in camera memory for use at next start up.
This function can work on external trigger mode.
Please refer Chapter 7.5 operation mode for the details.
The S/N ratio of the output will remain constant for all channels
8.7
Command BA – Bit Allocation
This function lets the user select whether the video data is presented as 3 x 8 (24)-bit or 3
x 10 (30)-bit on the Camera Link output. The internal processing in the camera is based on
a 12 bit A/D signal. The 24-bit and 30-bit function removes the least significant bits from
the 12 bit signal.
Settings:
0=24-bit, 1=30-bit
Applicable modes:
All
8.8
Command BI – Binning (Horizontal only)
This function reduces the number of pixels to 256 without affecting the line rate. Two
adjacent pixels are combined at the output stage and read out as one pixel. Sensitivity is
doubled as a result of binning.
Settings:
1=binning on, 0=binning off
Applicable modes:
All
Important Note:
Setting data is stored in camera memory for use at next start up
This function is available for all modes.
