JAI AD-130GE, User Manual

Page: 67 / 87

AD-130GE
66
10.5.7.2 Initial settings
The following are the default settings.
Camera 0 Sequence Control
Sequence Mode Off
Sequence Repetition Count 0
Last Sequence 1
Sequence Selector
Sequence
Repeat Count
in Each Step
ROI
Exposure Time
Raw
Master Gain
Raw
Size Offset
X Y X Y
Sequence 1 1296 966 0 0 982 0 1
Sequence 2 1296 966 0 0 982 0 1
Sequence 3 1296 966 0 0 982 0 1
Sequence 4 1296 966 0 0 982 0 1
Sequence 5 1296 966 0 0 982 0 1
Sequence 6 1296 966 0 0 982 0 1
Sequence 7 1296 966 0 0 982 0 1
Sequence 8 1296 966 0 0 982 0 1
Sequence 9 1296 966 0 0 982 0 1
Sequence 10 1296 966 0 0 982 0 1
Camera 1 Sequence Control
Sequence Mode Off
Sequence Repetition Count 0
Last Sequence 1
Sequence Selector
Sequence
Repeat Count
in Each Step
ROI
Exposure Time
Raw
Master Gain
Raw
Size Offset
X Y X Y
Sequence 1 1296 966 0 0 982 0 1
Sequence 2 1296 966 0 0 982 0 1
Sequence 3 1296 966 0 0 982 0 1
Sequence 4 1296 966 0 0 982 0 1
Sequence 5 1296 966 0 0 982 0 1
Sequence 6 1296 966 0 0 982 0 1
Sequence 7 1296 966 0 0 982 0 1
Sequence 8 1296 966 0 0 982 0 1
Sequence 9 1296 966 0 0 982 0 1
Sequence 10 1296 966 0 0 982 0 1
Caution
：
1
．
In the Sequential EPS Trigger, LVAL sync operation is not available as the different
exposure time and gain in each sequence table can be set. The trigger should be applied in
LVAL Async timing.
2
．
In order to change values in the Sequence Table are changed, image capture must be
stopped.
10.5.8 Delayed Readout EPS and PWC Modes
This mode can be used to delay the transmission of a captured image. When several cameras
are triggered simultaneously and connected to the same GigE interface, it allows the cameras
to be read out in sequence, preventing congestion.
The image data is not transmitted directly by the Frame Start Trigger and is stored in the
memory located at the Ethernet Interface. By the leading edge of the Transfer Start Trigger,