AD-130GE
48
Exposure mode
To set the exposure method
The flow of these commands is shown below.
The following drawings are based on the conditions that the Acquisition mode is Single
and the Trigger selector is Frame Start.
If the acquisition start is set at ON (The acquisition is controlled externally)
If the acquisition start is set at OFF (The acquisition is controlled internally)
The following sections provide the details for each command set.
10.1.2 Acquisition mode
The AD-130GE has three settings for capturing images.
Single frame
AcquisitionStart command outputs one frame. Then the acquisition is stopped.
Continuous
AcquisitionStart command outputs frames until AcquisitionEnd is initiated.
10.1.2.1 Single Frame
In single frame mode, executing the AcquisitionStart command causes one frame to
be captured. After one frame is captured, this operation is automatically stopped.
In order to restart the capture, it is necessary to input the AcquisitionStart
command again. BlockID is not reset until AcquisitionEnd is input and is incremented
when the AcquisitionStart command is called.
◆
Normal single frame operation
1) AcquisitionStart command is input
2) AcquisitionActive becomes ―TRUE‖ (accepts capture)
Acquisition
Trigger Wait
Frame Start
Trigger Wait
Acquisition Active
Acquisition
Start
Command
Executed
Acquisition
Trigger Wait
Acquisition
Start
Trigger
Frame Start
Trigger
Acquisition
Start
Trigger
Acquisition
Status
Frame Start
Trigger Wait
Acquisition Active
Acquisition
Start
Command
Executed
Frame Start
Trigger Wait
Frame Start
Trigger
Acquisition
Status
Frame Start
Trigger
