JADEVER SCALE
SNUG III
2
Ⅱ
. Introduction and installation of products
2-1 Assembly specification of scale pan and windshield
Assembly of scale pan
1. In order to avoid the possible damage
while assembling the scale pan, please
make sure that the transportation
protecting screw (A) has been locked.
2. The pan set is consisted of a plastic base
and a stainless steel pan, please put
plastic base (B) on the scale first.
3. Use Philips screwdriver to lock fixing
screw (C) in the center of plastic base.
4. Put stainless steel pan (D) on plastic
base, and then loose transportation
protecting screw.
Assembly of windshield
1. Windshield is consisted of 5 components,
and they must be assembled together
before being used.
2. First assemble four sides of windshield (A,
B) by inserting A into B from top to bottom
(or from bottom to up).
3. Place the assembled windshield on the
scale body; make sure that the position of
D should face downwards, or rotate the
assembled windshield up and down if it
fails to be clutched after being placed on.
4. Then place upper cover (C) of windshield
on.
2-2 Removal of protecting screws
1. As shown by the arrow in the right figure,
you may turn anticlockwise the
transportation protecting screw direct with
fingers to loose it.
2. For locking the screw, you may push
gently the screw inwards with fingers
meanwhile turn it clockwise.
3. The transportation protecting screw must
be locked while transporting, storing,
disassembling or assembling the scale.
