Jacuzzi sasha, Use & Maintenance

Page: 42 / 168

42
NB: activation is conditioned by the number of programmes performed (refer to the Chapter
"Scale removal cycle").
It is not possible to use programmes if the scale removal cycle is in progress.
■
If desired, you may enrich the steam bath using your own preferred essences or suitable
scented oil sticks: remove the dispenser from its housing, as indicated, and insert one oil
stick per dispenser; or use a few drops of your preferred essence. Re-close the dispenser,
pressing it down until it locks.
The oil sticks are available from Jacuzzi® Service Centres; we advise cutting the oil stick into
two pieces, and placing one in each dispenser.
■
Turn on the main switch: the system will enter into "stand-by" mode and the ON/OFF
display key will light up white.
NOTE: when the appliance is powered, you must wait approximately seven minutes before
using the hammam (the thermometer symbol flashes); this time period allows the control
system to initialise the electronic management system.
■
Subsequent to this phase, press the ON/OFF key: it will light up blue and at the same
time, the keys associated with the programmes will turn on, those relative to the alarm
and scale removal. The display is ready to receive instructions.
NOTE:
- This mode lasts approximately one minute, after this time, if no key has been pressed, the
system reverts to "stand-by" mode.
- The activation of any key is indicated by an acoustic signal.
- If an audio kit is installed (optional), the keys relative to the audio system , will also light up
on on the display.
■
Select one of the three programmes and activate it by pressing one of the indicated
keys (once pressed, the key will turn blue):
WARNING: perform the following procedure if the Jacuzzi® remote control system has
been installed: press the key of the program selected, wait for it to go dim and press
again within 20 seconds.
- Tepidarium
- Hammam
- Calidarium
Note: there is insufficient scale softener fluid in the tank if the
keys indicated to the side (tepon+off) blink when one
of the programs is engaged; remember to fill the tank before star-
ting the anti-scale removal cycle (see relative chapter).
■
After a few minutes, steam will be released from the nozzles.
preliminary operations
each programme may
last up to 45 minutes
or follow a cycle
that lasts 12 hours
(refer also to the
Chapter “Functions
associated with
display lock”)
programme
activation