Page 49
Panel buttons have been pressed too many times
in a short period of time. Because this could cause
excessive wear on equipment components, panel
buttons are temporarily deactivated. Panel buttons
will automatically re-activate if no button is pressed
for 30 seconds.
Circuit board temperature has exceeded acceptable
limit. This message will disappear when the circuit
board temperature drops below acceptable limit. If
condition persists, provide shade for equipment side
of spa.
FREEZE PROTECTION
A potential freeze condition has been detected. No
action is required. Jets pump(s) operate until the
spa is out of danger. Note: This error commonly
occurs when the spa is first filled because tap water
is often very cold.
Communication between the control panel and/or
remote control panel and circuit board is faulty.
Contact your dealer or service organization.
“WATCHDOG” (spa is deactivated)
A problem has been detected which could cause
damage to the spa or its components. Contact your
dealer or service organization.
OPEN SENSOR (heater disabled) OR SHORTED
SENSOR (spa is deactivated) The high-limit temper-
ature sensor is non-functional. This must be
repaired only by a dealer or qualified service
organization.
OPEN OR SHORTED SENSOR (heater disabled)
The main sensor is non-functional. This must be
repaired only by a dealer or qualified service
organization.
