Page 36
10.0 Heating Modes
The control system in your spa activates a programmable “standard” or
“economy” mode which effects when the heater operates.
Refer to sec-
tions 10.1 and 10.2 below for additional information.
10.1 Standard Mode (Factory Default)
Standard mode is typically selected by customers in cold climates where
heat up times are extended due to lower ambient temperatures. In this
mode, water temperature is regulated by the set temperature which acti-
vates the heater automatically as needed.
10.2 Economy Mode
Economy mode is typically selected by customers in warm climates
where heat up times are minimized due to higher ambient temperatures.
In this mode, the water temperature is regulated by the set temperature
only when a prog
rammed filter c
ycle is running, unless in summer logic
(page 38).
10.3 Selecting Standard or Economy Mode
Press the
MODE
button to select either “Standard” or “Economy”
mode. The control panel’s indicator on the right side of the LCD changes
to indicate which mode is selected.
10.4 Clean-Up “Blow-Out” Cycle
The clean-up cycle is once per day in both Standard and Economy
modes at 12:00 (noon) for two minutes. This is not user programmable.
Jets pump 2 activates for one minute to circulate any water in the plumb-
ing. After 1 minute, jets pump 2 shuts off and jets pump 1 turns on, runs
for 1 minute, then shuts off.