Page 38
running, but no apparent change of operation will occur. However, when
“Economy” mode is selected (sec. 10.3, page 36), the heater activates
only during a programmed filter cycle.
When in a Summer Logic condition is active (see note below), the filter/
circulation pump will turn on for all programmed filter cycles.
Summer Logic: In warm weather, the water temperature in the spa
may exceed the set temperature. This condition may occur due to
heat transference from the filter/circulation pump and jets pumps.
If the water temperature is higher than 95°F (35°C) and rises two
degrees above the set temperature, a “Summer Logic” condition occurs
that deactivates the filter/circulation pump and optional ozonator (if
equipped). This safety feature cannot be altered!
The filter/circulation
pump and ozonator will remain off until the water temperature cools to
the set temperature (except between 12AM-2AM when the filter/circu
-
lation pump runs for it’s mandatory 2-hour cycle). To help prevent a
“Summer Logic” condition, it may be necessary to reduce filter/circula
-
tion pump cycles run times in warm weather.
To make adjustments, first press the
CYCLE
button to enter the filter
cycle programming mode. The LCD screen will display the following in
the upper right corner:
1*
This means the system is ready to accept your changes to the start time
for cycle number one. Simultaneously, the large four-digit display in the
center of the screen displays the currently programmed start time for that
cycle. At this point, you have four options. You may:
1. Press
WARMER
or
COOLER
button to adjust the start
time in increments of 30 minutes.
2. Press
CYCLE
button to display and adjust each subsequent
cycles start time. With each press, the currently programmed status
will be shown in the large four digit display. To adjust any displayed
value, simply press the
WARMER
or COOLER
button.
3. Press
SELECT
button to move down the menu from Start Time to
Duration, with each press, the currently programmed duration will be
shown in the large four-digit display. Press
WARMER
or COOLER
button to adjust the duration in increments of 15 minutes.
*Note: Number will
vary according to which
filter cycle is being
programmed.