Page 42
cartridge 24-hours (unless programmed otherwise). Large debris are fil
-
tered when either jets pump is running when the spa is in use or during a
programmed filter cycle. These pumps draw water from footwell suction
fitting and through a secondary water polishing bag filter. The exclusive
footwell “sweeper” suction fitting enhances filtration in the footwell area
by creating a “swirling” water motion to maximize particle agitation and
pickup.
To ensure optimum performance, the 24-hour ProClear™
skimming filter cartridge (A) must be cleaned every three
months and replaced once a year and the secondary
ProClear™
Plus polishing filter bag (B) should be emptied
weekly and replaced every 3 months.
To accomplish this,
refer to the following filter cleaning procedure.
Note: Do not
attempt to wash the polishing filter bag (B) or it will come apart!
ALWAYS TURN POWER TO THE SPA OFF BEFORE CLEANING THE
FILTER CARTRIDGES!
NEVER OPERATE SPA WITHOUT FILTER
LID (2) AND SKIMMER ASSEMBLY (4) INSTALLED.
A
B
2.
1.
3.
4.
5.
1. Remove power to the hot tub before removing the skimmer (A) or
filter bag cover (B).
2. Remove the polishing bag lid (B) by rotating it counterclockwise
approximately 5 degrees until you feel it unlatch.
3. Remove the polishing bag by reaching into the filter bucket
and gently pulling upward on the blue filter ring (empty
filter bag weekly or install a new bag every three months.)
Replace bag, then install filter lid by rotating it clockwise until
you feel it latch in place. DO NOT FORCE LID! FINGER
TIGHT ONLY!
4. Remove the ProClear skimmer assembly (A) by gently lifting
upward from the filter bucket.
5. Remove the ProClear filter cartridge by rotating it counter
-
clockwise to unthread it, then remove the center cap and
chemical dispenser from the filter cartridge as shown (right).
6. Clean the ProClear filter cartridge (A) with a garden hose
and high pressure nozzle. Rinse debris from the filter
A
B
A
B