PAGE 5
SCENECONTROL 500 OPERATING INSTRUCTIONS
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 1: February 15, 2007
SYSTEM LEVEL - in addition to Access and Edit Level features, user can perform the following:
•
create, delete, edit sets
•
edit
motors
CLANCY LEVEL - in addition to Access, Edit and System Level features, user can access certain system
base parameters. This level must only be used by factory-trained maintenance personnel.
SYSTEM STARTUP - STAGE VIEW
When the system boots up, the display screen will show the stage as viewed from the operator's position.
The name of each set will be indicated on a graphic representation of the set.
SHORTCUT OPERATIONS
DEADMAN OPERATION - SHORTCUT
To select a set (or sets) for operation, the operator touches the graphic corresponding to the set on the
touchscreen. The set label will change from white to green to indicate that it has been selected. A Vertical
Position window will also appear in the upper right portion of the screen. If the set is variable speed, a
Velocity window will appear in the lower right of the screen. If the set is multi-axis, pitch and roll windows will
appear in the lower right of the screen.
The operator may now push and hold the GO UP or GO DOWN pushbutton on the console to run the set.
The set will stop when the operator releases the pushbutton, or when the set arrives at its limit. The 3-D
display will update to reflect the reported position of the set - however, the display can't hurt anyone. While
the set is moving, remember - WATCH THE PIECE!
If the set is variable-speed, the operator can increase the speed of the set during the move by pushing the left
joystick (toward the GO UP button), and can decrease the speed by pulling the left joystick (toward the GO
DOWN button). When the left joystick is centered the set will run at the default speed.
