iTegno 39XX GPRS Modem
AT Commands Guide
02000C17
•
v1.5
Confidential
All specifications are correct at the time of release. iWOW Connections owns the proprietary rights to the information contained herein this
document. It may not be edited, copied or circulated without prior written agreement by iWOW Connections Pte Ltd. © 2011, 2012 iWOW
Connections Pte Ltd
167
CME ERROR: <error>
Read command
AT+XSIMSTATE?
+XSIMSTATE: <mode>
OK
Test Command
AT+XSIMSTATE=?
+XSIMSTATE: (0,1)
i.e. (list of supported <mode>’s)
OK
Defined values
<mode>
parameter sets the result code presentation in the TA:
0
disable
1
enable
10.32
Rx DivXRXDIV
This command is used to allow external control of the Rx Diversity feature during runtime. A supporting
parameter can also be changed. The feature can be enabled or disabled during operation, and one classmark
field may be changed. Readback of the feature enable and the classmark field is also provided.
This command will allow the AP to enable or disable the feature:
<RxDivEnbl> = enabled or disabled
This enable is used primarily by Layer 1 (L1U/3G, L1G/2G), and is applied under different circumstances when
changed. For 3G, the enable setting is changes at the next DCH setup.
For 2G, the enables setting is changes when the UE registers with the network (LocUp/Attach).
There is a default copy of the enable stored in non-volatile memory. This enable may only be changed via
Phonetool. It is intended that this default feature enable will be setup once, during production. The default
setting will be selectable by the customer.
At powerup, the non-volatile copy is read and used to control the feature by L1U and L1G.
When the enable setting is changed using the XRXDIV command, the new setting will override the initial
version, until the next power cycle. The non-volatile copy will not be changed.
The command will also allow the <DARP> field (darp_caps field in the T_CLASSMARK_3 structure) to be set to
one of these values:
