Italkero Poster PE t1 30, Installation And Technical Manual

Page: 23 / 56

Chimneypot assemblage
To assemble the chimneypot on the unloaded intake
tubes use the clamp (1) and the (2) safety screw.
The chimneypot application has to satisfy the fol-
lowing requirement.
-The top of the exhaust fume tube has to be out of
the ebb zone, to avoid the eventual pressures that
will prevent the free exhaust product of the combu-
stion in the atmosphere.
-The chimneypot has to be placed right on top of the
tube in the proper way, if it
ʼ s not placed in the proper
way, the fumes will get inside the tubes, and if this
happen it will cause problems to the convector.
CONVECTOR ASSEMBLAGE
The proper function of the radiator has to be couple
to the tube Ø 54 mm it foresees the application of the
diaphragm (1) supplied with the apparatus equip-
ment.
Fitting the diaphragms (Ø 54 mm pipes only)
is required and recommended only for
models 30, 50 and 70.
Diaphragm fitting is NOT required for model 90.
The diaphragm has to be inserted inside the air intake
curves (2) and unloaded fumes (3) before assembling
the convector on the template.
Remove the humidifier and the cover from the convec-
tor unscrewing the fasting screw.
Rest the inferior part of the convector at the inferior tem-
plate adages; fasten to the wall or on the spacing bar.
Approach the apparatus, inserting the unloaded
/intake fumes curves in the right adapter connection
tubes.
To fasten the tubes use grease and be sure that
the O Rings are in their seating.
Lift the apparatus, place it next to the hanger, and
then fasten with stud bolt (5 ma) (4).
Do not lift the convector holding it from the fan,
trying emitting damage.
Check the work done.
Reassemble the cover and the humidifier after the
electrical and gas connection.
2
1
4
5
4
5
23
INSTALLATION