CNC Base machinery / CNC machinery: Type EuroMod
Assembly instruction / Operating instruction for EuroMod 30, 45, 65
page 5
1 Introduction
All
isel
CNC base machinery (corresponding MD 2006/42/EC
partly completed
machinery
) respectively
isel
CNC machinery (corresponding MD 2006/42/EC
complete
machinery
) of type EuroMod (evenso machinery of type FlatCom, OverHead and
ModuStar) are proven CNC machinery. They provide the user a wide range of possibilities
for 2D or 3D processing of work pieces.
Machinery are constructed in different sizes and accomplishments. The base are exactly
fitted and variable mountable standard profiles and drive units. Depending from the
machinery demands according kinematics the units are mounted. The appearance of
machine of one type is always the same. Applications of a concrete machine respectively
the tool mounted on the Z axis are variously.
All CNC base machinery / CNC machinery of type
EuroMod
have a unique control and
safety concept as well as a unique design of the mechanics. Each single machine becomes
configured, measured and tested for many hours before delivery to the customer.
For every delivered CNC base machine / CNC machine a check protocol is archived under
the special order number at the manufacturer isel Germany AG. The customer can request
this protocol. All CNC base machinery / CNC machinery are surveyed with circle form tester
QC10 from
Renishaw
® in all three interpolation planes resp. Laser interferometer.
As presupposition for your work you need basic knowledges in CNC technics and PC
application. It would be good to know also the terminology of the current valid MD:
-
MD
98/37/EU
applicable
until 28.12.2009
-
MD
2006/42/EU from 29.12.2009
obligingly by law
Please note this manual that you
• install and do commissioning of CNC base machine / CNC machine correctly
• can work safety, fast and effectively
• keep away danger from persons and the equipment
• can fully profit from the capabilities of CNC base machine / CNC machine
The statements in this manual orientate to a standard complexity of deliver the CNC
machine is ready for operation. Notes not related to the machine (e.g. accessory or
software) you can skip when reading the manual the first time.
The statements in this manual are basing on the following configuration / technical state of
the CNC machine control system:
all motor amplifiers have
monitoring of standstill state
Operator software is:
ProNC /6/ or / Remote /7/ higher then version 1.45.6.0
For installation and commissioning the software or accessory please note the
supplemental manuals. They are composed in the bibliography of this manual.
