TM3215,3245,3265
82
Front Axle End-Float
FIG. 6-47:
Fore and aft play of the front axle (1) in its
supports should be 0.1 to 0.3 mm (0.004-0.012”). End-
float is measured with axle raised off the ground.
Loosen the lock nut (2) and turn the adjusting bolt (3)
as needed to achieve correct measurement. Tighten the
lock nut.
NOTE: Excessive end-float will cause noise. This noise
will be more pronounced when using 4WD.
CLUTCH HOUSING PLUG
FIG. 6-48:
Pipe plug (1) should be removed from the
bottom of the clutch housing once a year or when clutch
slipping is apparent. Any oil leakage from the engine
rear crankshaft seal and / or transmission input shaft will
be indicated by oil draining through the hole. Contact
your ISEKI dealer if oil leakage is evident.
TORQUE CHART
FIG. 6-49:
All fasteners should be tightened in accor-
dance with the torque chart unless a specific torque
value is called out in relevant maintenance information.
1
2
3
FIG. 6-47
1
FIG. 6-48
FIG. 6-49
