Iseki SBC550FH, Operation Manual

Page: 125 / 152

SFH220,240
124
9. PERIODICAL INSPECTION TABLE
IMPORTANT:
・
Above mentioned service intervals should be used as reference criteria. If working conditions are harder, earlier
service is recommended.
・
When special technology and special tools are required, consult your dealers.
○
Check points Intervals after that Judgement criteria
Ref.
page
Inspection and
servicing intervals
(hours of operation)
Pre-
operation 50 100 150 200 250
Blade
Gear case oil
Belt tension
Inflation of
gauge wheel
Replace after initial 50 h.
and then after every 200 h.
Deformed, broken, worn,
and cracked ones should be
replaced.
Maintain the specified level.
Spring length: 137mm
● ○ ○ ○ ●
○
107
106-B
105
−
△
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Clean after every 50 h.
Clean after every 50 h.
Grease up after every 50 h.
There should be no lost or
deformed ones.
2.1 kgf/cm
2
There should be no grass or
dust accumulated.
Criteria for replacement:
・
Deep crack over half the
thickness of belt.
・
Worn out side wall canvas
There should be no loose ones.
They should turn smoothly.
Rollers and gauge
wheels
Belt cover inside
Belt
Greasing points
Bolts and nuts
Pins and crips
−
107
00
−
109-A
107
○
○
○
○
△ △ △ △
○
: Inspection, replenishment, and adjustment
△
: Cleaning and washing
●
: Replacement
★
: Consult your dealer.