Iseki SBC550FH, Operation Manual

Page: 46 / 152

CHAPTER 5. CONTROLS AND METERS
45
6.2. C O L L E C TO R H Y D R A U L I C D U M P L E V E R
(DOUBLE ACTING HYDRAULIC LEVER)
This lever is used for dump the SBC550 collector when
it is attached. The lever shifted upward(A), collector
dumps, the lever shifted downward(B), the collector
back to original position.
When the collector is dumped, if the blower lever is
shifted to "on" position the engine will be stopped by
safety switch.
7.1. SAFETY SWITCHES
The safety devices are equipped on the operator's seat,
master brake pedal and PTO levers. Before starting
engine, the operator should be seated in the operator's
seat, depress the master brake fully and shift the both
side and center PTO levers to the OFF position.
CAUTION: When the engine does not start
due to a defective safety switch or does
not stop when the operator has left the
operator's seat, consult your dealer at once
without fail.
7.2. SAFETY SWITCHES (F2 type)
The safety devices are equipped on the operator's seat,
master brake pedal and PTO levers and engine hood
open. Before starting engine, the operator should be
seated in the operator's seat, depress the master brake
fully and shift the both side and center PTO levers to the
OFF position and engine hood is closed.
CAUTION: When the engine does not start
due to a defective safety switch or does
not stop when the operator has left the
operator's seat, consult your dealer at once
without fail.
HST UNLOADING LEVER
Turn this lever upward to unload the HST of pressure,
which allows the front mower to move by pushing
without starting the engine.
WARNING: After operation, be sure to
check to see that the lever is returned to the
CLOSE position.
FIG. 43
FIG. 44
Hydraulic oil filter Hydraulic oil filter
HST unloading lever HST unloading lever