IPG Intertape RSA 3036-SB, Operation Manual

Page: 18 / 93

UDM644-00 RSA3036-SB Manual 18
UM644TW
Figure 17
Pull approximately twelve (12) inches of tape from the roll and fold in half lengthwise.
This allows you to thread the tape without it adhering to the guide and clutch rollers
inside the Tape Head.
Follow the tape-threading diagram on the side plate of the HSD

2000-ET II Tape Head.
Refer to your Tape Head manual for further information if required.
Operate the blade guard from the knife in the Tape Head to cut off the folded tape.
Replace the upper Tape Head to its initial position.
To thread the lower Tape Head, no special tools are required.
Reconnect machine and turn the operation selection button on the Stop/Start box to
"bottom only" (BOTT). This will place the top Tape Head box to the uppermost position.
Re-disconnect the machine to proceed the tape threading.
Remove the lower Tape Head by grasping the tape application rollers and lifting straight
up.
Pull approximately twelve (12) inches from the roll and fold in half lengthwise. This
allows you to thread the tape without it adhering to the guide and clutch rollers inside the
Tape Head.
Follow the tape-threading diagram on the side plate of the HSD

2000-ET II Tape Head.
Refer to your Tape Head manual for further information if required.
Operate the blade guard from the knife in the Tape Head to cut off the folded tape.
Reconnect the machine.