IPG Intertape RSA 3036-SB, Operation Manual

Page: 17 / 93

UDM644-00 RSA3036-SB Manual 17
UM644TW
Air Pressure Regulators
The Air Regulators are factory-preset. There are four (3) Air Regulators for the RSA
3036-SB without the Compression Guides and five (4) for the carton sealer with the
Compression Guide option. The recommended air pressure is indicated on the top of
each air pressure dial.
For the Top Tape Head Box, the air
pressure dial is located on the left:
BALANCE. The Drive Base air
pressure regulators are located
immediately to the right of the Top Tape
Head Box regulators: DRIVE BASE -
OPENED and DRIVE BASE -
CLOSED. The Air Pressure Regulator
for each component is located under the
machine directly below each
corresponding air pressure dial.
Figure 16
Tape Loading and Threading
Warning! Turn off electrical power supply and disconnect the power cord from
the electrical supply before beginning to work on the Tape Heads or
to load tape. If power cords are not disconnected, severe injury to
personnel could result.
The HSD

2000-ET II - 2 in. tape heads accommodate 48 mm (2" nominal) wide tape
rolls, while the optional HSD

2000-ET II- 3 in. tape heads accommodate 75 mm (3"
nominal) wide rolls. See the label on the side of the HSD

2000-ET II tape head for the
loadable tape sizes.
Warning! The knife contained in the Tape Head is extremely sharp. Use caution
when removing the blade guard and threading the tape to avoid
personnel injury.
To thread the tape in the upper Tape Head, you do not require any special tools.
Push the Tape Head towards the in feed of the machine and lift up (refer to fig.17).
Balance
Pressure
70psi Drive Base
Opened
30psi Drive Base
Closed
30psi