LIP-9000 Series
User Guide - ST- Issue 1. 5
11
1.7 Wall Mount
The LIP-9000 series phones can be wall mounted as needed. The following
instructions describe the wall mount installation. Note the foot-stand must
not be installed.
1.
If installed, remove the foot-
stand from the Phone and
Button kit.
2.
Connect all wiring to the
Phone as described in “1.5
LIP-9000 Phone Installation”.
Connect the Phone side
wiring only.
3.
If required, install the Button
kit.
4.
Align the wall-mount bracket (ordered separately) over the back of the
phone, then press the bracket onto the phone applying steady pressure
until it clicks into place.
5.
Install the Button kit wall-mount bracket if required, in the same manner
as the bracket for the phone.
6.
Mark and drill two 7mm holes for plastic wall anchors (not included).
7.
Insert the two anchors into the holes, and insert and tighten the two
screws (not included) leaving about 2.5 mm (1/8-inch) exposed.
8.
Align the key holes in the bracket over the screws and slide the phone
down assuring the phone is secure.
9.
Remove, reverse and re-install the handset hook so that the hook
catches the groove in the handset receiver.
10.
Hang the handset up on the handset hook.
11.
Complete all wiring connections as described in “1.5 LIP-9000 Phone
Installation”.
NOTE
It may be necessary to remove the phone and tighten or loosen the screws
for a secure mounting.
Summary of Contents for LIP-9000 Series
