Transport
The safety belt installed in the transporting vehicle should be applied
as shown in the illustration above.
1) Center line of the body
2) Center of the sternum
10.4
Transporting the mobility device without
occupant
CAUTION!
Risk of injury
–
If you are unable to fasten your mobility device
securely in a transport vehicle, Invacare recommends
that you do not transport it.
•
Before transporting your mobility device, make sure the motors
are engaged and that the remote is switched off.
Invacare strongly recommends that you additionally disconnect
or remove the batteries. Refer to Removing the batteries.
•
Invacare strongly recommends securing the mobility device to
the floor of the transporting vehicle.
10.4.1
Opening the rear cover
Removing the rear cover:
1.
Loosen and remove the two knobs (1) on the left and right side
of the rear casing.
2.
Lift the rear cover carefully. The front part of the cover is held
at the top by a Velcro strip. This must also be released.
Fitting the rear cover:
1.
Fit the parts in the reverse order.
2.
Tighten the two knobs by hand.
10.4.2
Making the batteries accessible
WARNING!
Fire and burn hazard due to short circuit at
battery poles
–
DO NOT short-circuit the battery poles with a tool
or metal parts of the wheelchair.
–
Make sure that the battery pole caps are attached at all
times when you are not working on the battery poles.
CAUTION!
Risk of crushing
The batteries are very heavy. There is a risk of hand
injury.
–
Be aware that the batteries are very heavy.
–
Handle the batteries with care.
Be careful when handling small parts such as screws and
washers during disassembly. Place the small parts down in
a way that makes it easy to reassemble them in the correct
order.
1529686-P
91
