Invacare® Storm®⁴
1.
Block up the vehicle (place wooden blocks under frame).
2.
Unscrew valve cap.
3.
Depressurize tire by pressing in the pin in the valve (1).
4.
Unscrew 5 screws (2).
5.
Remove the wheel rim halves.
6.
Remove the inner tube from the tire.
If the old inner tube is to be repaired and re-used,
and has become wet during repair, you can make
replacement easier by sprinkling the inner tube with a
little talcum powder.
7.
Repair inner tube and replace, or insert new.
8.
Replace the inner tube in the tire.
9.
Insert the wheel rim halves once again.
10. Insert the screws and tighten slightly.
11. Pump a little air into the inner tube.
12. Tighten the screws to 25 Nm.
13. Ensure that the tire outer is seated correctly.
14. Pump the wheel up to its prescribed air pressure. Refer to 12
Technical data, page 95.
15. Check that the tire is seated correctly once again.
16. Screw the valve cap back on.
9.4.3
Repairing a flat front tire (pneumatic tire
3.00-6")
Requirements:
•
Allen key 5 mm
•
Open-end spanner 24 mm
•
Repair kit for inner tubes
or
a new inner tube.
•
Talcum powder
Remove the wheel
1.
Jack the vehicle up and place a block of wood underneath it to
prop it up.
2.
Remove the plastic cap (1).
3.
Loosen and remove the nut (2) using the open-end spanner.
4.
Remove the washer (3).
5.
Take the wheel off of the fork assembly.
Re-assembly is done in reverse order. Make sure that the
wheel is put back on the same side it was on, and that it runs
in the same direction it did before it was removed.
Repair the flat tire
84
1529686-P
