Adjusting the mobility device to the user's seating posture
NOTE
–
Activate the motor brakes (engage motor) before
adjusting the seat angle.
–
Only adjust the seat angle manually if nobody is sitting
in the seat.
Requirements:
•
1 x 6 mm Allen key
1.
Switch the power supply off (ON/OFF key).
2.
Unscrew Allen screws (1).
3.
Adjust the seat angle by raising or lowering the seat.
4.
Insert the Allen screws again and tighten.
6.7
Adjusting the backrest
CAUTION!
Adjusting the seat tilt or the backrest angle
changes the geometry of the mobility device and
directly influences its dynamic stability!
–
For details regarding dynamic stability, negotiating
gradients and obstacles and the correct adjustment
of seat tilt or backrest angle, refer to 5.3 Taking
Obstacles, page 24 and Driving up and down gradients.
6.7.1
Electrical
Consult the user manual for your remote for information about
electrical adjustment.
6.7.2
Adjusting the backrest (standard seat) —
manually with handscrews
1.
Remove the screws (1) on both sides of the backrest that hold
it in position.
2.
Set the backrest to the desired angle by selecting a combination
of one of the two holes in the backrest frame, and one of the six
holes in the metal fixation plate.
3.
Re-position screws and tighten them.
1529686-P
39
