Adjusting the mobility device to the user's seating posture
5.
Repeat these operations on the other side of the seat.
6.
Undo and remove the two Allen screws (5) including washers.
Assembly:
1.
Pull the seat support to the required length so that the Allen
screws (5) can be inserted in the holes in accordance with the
table (see above).
2.
Insert the Allen screws (5) including washers again and tighten
them.
3.
Fit the two Allen screws (8) which are located at the rear of the
seat support, and connect them with the crossmembers (4). You
must be using other holes within the 3 hole pairs for the screws
than you did during dismantling.
4.
Refit all the parts you have removed.
6.13.4
Adjusting the seat depth with replacing the
seat support plate
Exploded drawing of seat support
Disassembly:
1.
Remove the legrests.
2.
Remove the armrests.
3.
Remove the seat cushion.
4.
Remove any cable ties which hold cables from the remote or
lighting which have been fitted. Remove the cables from any
clips which have been glued on.
5.
Undo the cap nuts on the headlight holders with an 8 mm jaw
spanner.
1529686-P
51
