![background image](http://html1.mh-extra.com/html/intex/purespa-ps-bh-10/purespa-ps-bh-10_owners-manual_2081445015.webp)
292
PO
S AVE THESE INSTRUCTIONS
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016
English
Page 15
LED CODE CHART
LED Reading
CAUSE
SOLUTION
E80
Water control valve broken
•
Contact Intex Service Center.
E90
No water flow
•
Turn off and unplug the control unit.
•
Ensure the outlet cover grid is clean and free
from obstructions.
•
Ensure the in/outlet connections on the spa tub
and filter pump are not blocked.
•
Keep the spa water properly sanitized.
•
Be sure the filter cartridge is clean and not
clogged.
•
If problem persists, contact Intex Service
Center.
E94
Water temperature too low
•
If the ambient temperature is below 39°F (4°C),
we recommend you do not use the spa.
•
Turn off and unplug the control unit, add some
warm water to raise the spa water temperature
above 41°F (5°C), then press the
104
F
o
button to
heat up the water to the desired temperature.
•
Press the temperature increase button to set
the desired water temperature.
•
If problem persists, contact Intex Service
center.
E95
Water temperature too high
•
Turn off and unplug the control unit. When the
water has cooled down, plug the GFCI/RCD
and restart all over again.
•
Turn the heater off, then press the filter and
bubble buttons to lower the water temperature.
•
If problem persists, contact Intex Service
Center.
E96
System Error
•
Turn off and unplug the control unit, use the
cap to stop the water from flowing out of the
tub, disassemble and drain out the control unit.
Reassemble the control unit back to the tub.
Plug the GFCI/RCD and restart all over again.
•
If problem persists, contact Intex Service
Center.
E99
Water temperature sensor broken
•
Contact Intex Service Center.
END
After 72 hours of continuous
heating operation, the pump will
hibernate automatically. The rapid
heating and water filtration
functions are disabled.
•
Press the
104
F
o
button to re-active the
filter pump.