![background image](http://html1.mh-extra.com/html/intex/purespa-ps-bh-10/purespa-ps-bh-10_owners-manual_2081445008.webp)
292
PO
S AVE THESE INSTRUCTIONS
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016
English
Page 8
Site preparation and requirements
• For outdoor installation only. For household use only.
• The spa must be setup on a level, flat and smooth surface that is capable of supporting the maximum load
of the filled spa with four adult occupants; weight 5800 lbs (2647 Kg).
• Make sure the area is free of sharp objects under or around the spa.
• Provide adequate drainage system around the spa to deal with overflow water and splashes.
• Provide a properly located power outlet to connect the spa and allow easy access for periodic testing of the
cord mounted GFCI/RCD.
• Make sure there is enough clearance around the spa for full access to the spa equipment for maintenance
and/or service.
• The area shall facilitate draining purposes during long term spa storage.
• Make sure the floor is water resistant and non-slip surface. Do not install the spa on carpet or other
materials that will be damaged by moisture, condensation.
• Spa owners may need to comply with local or states laws relating to childproof fencing, safety barriers,
lighting, and other safety requirements. Contact your local building code enforcement office for further
details.
• Do not setup the spa on grass or dirt, as this increases the amount of debris entering the spa, and damage
the spa floor.
• Do not expose the spa to direct sunlight for extended period of time.
• It is possible to install and leave the spa outside at a temperature not lower than 39°F (4°C) provided the
water temperature inside the spa is higher than 39°F (4°C) and the water inside the circulation system,
pump, pipe are not frozen. Put a “temp barrier mat” between the spa floor and the ground to prevent heat
loss from the bottom of the spa and to provide better heat retention.
SET UP