292
PO
S AVE THESE INSTRUCTIONS
(292PO) BUBBLE SPA WITH POOL ENGLISH 7.5” X 10.3” PANTONE 295U 01/26/2016
English
Page 12
SET UP (continued)
Spa Control Unit Installation
1.
Connect the spa control unit to the spa tub
(see drawing 15)
. Hand-tighten the connectors securely.
Do not use tools to tighten.
2.
Reinstall the back cover
(2)
to the spa control base
(see drawing 16).
CAUTION:
Back cover must be installed before using the SPA.
Do not sit, lean, cover or place
any objects over the spa control unit.
3.
Inflate the spa tub first before installing filter pump fittings. Attach
two filter cartridge housing assemblies to the two lower outlet grids
on the inside of the spa “A” side. Attach remaining two filter cartridge
housing assemblies to the two lower outlet grids on the inside of the
“B” side.
ATTENTION!
In order to comply with the requirements of the
Virginia Grahame Baker Act, suction outlets cannot be covered
while the spa is in use. The Act was intended to address high
suction / volume circulation systems but does not exclude low
volume systems as used on this spa. Accordingly, remove the filter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage
(see drawing 17)
. Re-attach them
after usage for water filtration and cleaning.
4.
Before filling with water make sure the bottom drain valve caps are securely closed on the inside and
outside on both sides of the tub.
5.
Fill the spa tub with freshwater to a level between MIN and MAX marked on the inside of the spa wall.
Do not over fill the spa. Never move the spa tub with water inside and/or with the control base attached
to the spa as the spa or control base may be damaged.
WARNING:
Never pour water with a temperature higher than 104°F (40°C) into the spa directly. It is
recommended to fill the spa tub with lukewarm water for quick heating and energy saving. Both sides of
the tub must be filled with water to the recommended level.
6.
Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT:
Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
7.
Ensure the spa is plugged into a grounded electrical socket and press the
104
F
o
button to turn on the
control unit panel buttons first. Press the
104
F
o
button on the control panel to activate the heater, see “Spa
Control Unit Panel” operation section.
17
16
2
15
