Intesis
Box
®
KNX - Haier A.C. (VRF line)
User's manual r1.0 EN
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox is a registred trademark of
Intesis Software SLU
URL
tel
http://www.intesisbox.com
[email protected]
+34 938047134
16 / 31
➢
Sequence for +/- object
This parameter lets choose between the different modes available:
•
S1>S2>….>SN
Select this option if you don’t have Auto mode and you don’t want roll
-over to be
enabled.
•
S1>S2>….>SN>S1>…
Select this option if you don’t have Auto mode and you want roll
-over to be
enabled.
•
Auto>S1>S2>….>SN
Select this option if you have
Auto mode and you don’t want roll
-over to be
enabled.
•
Auto>S1>S2>….>SN>Auto>S1>…
Select this option if you have Auto mode and you want roll-over to be enabled.
4.3.4
Enable use of bit-type Fan Speed objects (for Control)
This parameter shows/hides the bit-type
Control_ Fan Speed
objects.
13:
14:
15:
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Control_ Fan Speed
objects for Speed 1, Speed 2 and Speed 3 (if
available) will appear. To activate a Fan Speed by using these objects a
“1”
value has to be
sent.
▪
Up / Increase
▪
Down / Decrease
Fan Speed 3
Fan Speed 1
Fan Speed 2
Only if Roll-over is enabled
Only if Roll-over is enabled
