Intesis
Box
®
KNX - Haier A.C. (VRF line)
User's manual r1.0 EN
© Intesis Software S.L.U. - All rights reserved
This information is subject to change without notice
IntesisBox is a registred trademark of
Intesis Software SLU
URL
tel
http://www.intesisbox.com
[email protected]
+34 938047134
14 / 31
4.3
Global Fan Speed Configuration dialog
Figure 4.13
Default Fan Speed Configuration dialog
All the parameters in this section are related with the Fan Speed properties and communication
objects.
4.3.1
DPT object type for fan speed
With this parameter is possible to change de DPT for the
Control_ Fan Speed
and
Status_ Fan
Speed
byte-type
communication objects. Datapoints Scaling (DPT_5.001) and Enumerated
(DPT_5.010) can be selected.
o
When
“Enumerated [DPT 5.010]”
is selected,
Control_ Fan Speed
and
Status_ Fan Speed
communication objects
for this DPT will appear. Also, depending on the number of fan
speeds selected, these objects will be different.
11:
34:
The first fan speed will be selected if a
“1”
is sent to the
Control_
object. The second
one will be selected sending a
“2”
, and the last one sending a
“3”
.
The
Status_
object will always return the value for the fan speed selected.
Important:
If a
“0”
value is sent to the Control_ object, the minimum fan speed will be
selected. If a value bigger than
“3”
is sent to the Control_ object, then the maximum
fan speed will be selected.
o
When
“Scaling [DPT 5.001]”
is selected,
Control_ Fan Speed
and
Status_ Fan Speed
communication objects
for this DPT will appear. Also, depending on the number of fan
speeds selected, these objects will be different.
11:
34: