S T A R G e n 2 R e c e i v e r U s e r ’ s G u i d e
Page 13 of 47
Decoder
Decoder Audio
CHANNEL x Audio:
STREAM: when stream is set to MPE then select from:
MODE: OFF, CHAN.GUIDE, USER DEFINED, TONE.
Note: If Channel Guide mode is selected, the receiver will populate the service list automatically.
The channel information is provided by the SDP packets from the Event Managers at the head-
end. The MPE PID (ECG PID) for the SDP packets must be added to the receiver PID list to get
the list of Services. The Channel Guide is the list of programs you can select in MPE mode. The
user selects the wanted service, and the unit will select the appropriate IP address and PORT
number. In MPE mode this address and port has to be done manually.
Note: If tone is selected the receiver outputs a 1Khz note.
STREAM: when stream is set to PES then select from:
MODE: OFF, PSI, PID, TONE.
Note: In PSI mode the receiver will populate its service list from the PSI table in the DVB carrier.
The user selects the wanted service, and the unit will select the appropriate PID. In PID mode this
PID has to be set manually.
Note: If tone is selected the receiver outputs a 1Khz note.
SERVICE: shows the list of services available. When there
is no list “SIGNAL?” will be shown.
15 kHz LOWPASS: ON/OFF. Enabling the low pass filter limits the upper frequency range to 15Khz
with a 3db/octave attenuation.
GAIN: Set the gain from -18 to +18 dB, in steps of 1 dB.
STEREO/MONO: Select Stereo (Dual), Mono L+R, Mono L, Mono R.
DELAY: Input presentation delay from 0 to 8000 milliseconds.
