Intermec Trakker T2090, User Manual

Page: 203 / 246

BIOS Support
7-17
7
UPDATE PROGRAM SYNTAX:
update [/F filename ] [/COM# ] [/Bbaud]
where:
filename is your image file
# is a COM port number (default=1, such as COM1)
baud is a valid baud rate (9600, 19200, 38400 . . . or 115)
(default baud rate=115)
The following screen appears:
FLASH UPDATER PROGRAM
copyright 1998, Intermec Technologies Corp.
1) Reboot the T2090 and enter Setup by hitting F1 during boot
2) Enter Setup password (default 123) and select LOAD FILE
3) Set the correct Baud and select START LOAD
Remote Drive = G: Local Drive = C:
Remote Disk v6.22 (Revision 2.50.11) (XT)
Copyright © 1989-1997 Datalight, Inc.
Installed as Drive G: /COM1 / /T10
Waiting for drive, Put T2090 in cradle!
If unit wasn’t in remote mode, then there may be a delay
Hit a key to Terminate
Looking for Drive G: . . . . .
7. On the T2090, enter setup by first turning the unit off and then depressing
the F1 key immediately upon power up.
If the real-time clock has not been set, you will be asked to set the time.
Press F3 to accept the default. The clock will be reset after the load. The
setup program may also be entered by typing FWTSETUP.
8. Once in setup, enter the password (default=123) and select LOAD FILE. Set
the Baud Rate to 38400 and select Start Load RT.
9. Replace the T2090 in its cradle. The PC will automatically detect the T2090
in remote mode and begin sending files. Once the PC changes screen and is
in SERVER mode, then select BACK and QUIT on the T2090. This causes
the unit to reboot.