Intermec Trakker T2090, User Manual

Page: 149 / 246

Configuration Command Reference
6-5
6
Parity Even
Poll (Polling) Disabled
Start of Message (SOM) \x02 (hexadecimal value for STX)
Stop Bits 1
Timeout Delay 10 seconds
Entering Variable Data in a Configuration Command
You can enter variable data for many of the configuration commands. For
example, you can set a preamble that is up to 25 ASCII characters long. You
need to follow these general instructions to enter variable data.
To enter variable data in a configuration command
1. Scan a bar code label with this syntax:
+/$+ command
where:
+/ is the syntax for the Enter Accumulate Mode command.
$+ is the syntax for the Change Configuration command.
command is the syntax for the command you want to change.
For example, the command syntax for a preamble is ADdata. To change or
set a preamble, scan this bar code:
Enter Accumulate Mode / Change Configuration / Set Preamble
*+/$+AD*
*+/$+AD*
2. Scan a bar code label from the “Full ASCII Charts” in Appendix C. To set
the preamble to the character T, scan this label:
T
*T*
*T*
Note: To use the bar code labels in Appendix C, you must configure the computer
to use Code 39 in Full ASCII mode. For help, see “Code 39” later in this chapter.